हिंदी Call90310 74624
Home›Pumps›Nova NH01 0.5 HP
Pumps · Nova · we sell it

Nova NH01 0.5 HP self-priming pump in Muzaffarpur: what it suits, what to read on it, what to buy with it

The short answer

The NH01 is the smaller of our two Nova pumps: a 0.5 HP, single-phase, self-priming pump for a house with shallow water. Take it for a ground-floor or G+1 house, tank on the roof, water within about 5 m below the pump even in May, one or two bathrooms. Taller house, more bathrooms or a long pipe run: the Nova NF01, 1 HP. Water deeper than the pull limit: a submersible, not more HP.

How to choose is worked out in 0.5 HP or 1 HP and self-priming or submersible. This page is about the pump itself: what to read on it, and what to buy with it. Price: Ask rate per pump, today's figure on the rate board, with GST on the bill.

0.37 kW
Motor power0.5 HP at 746 W a horsepower. The volts and amps are on the nameplate.
7 m
Pull we plan onMeasured in May, whatever the box says. Deeper: submersible.
16 A
C-curve MCB, own lineOn 2.5 sq mm wire. Read the amps first.
The six figures to read on the pump
Where to read the pump's figuresA pump with its suction port A on the left and delivery port B on top, and a yellow nameplate on the motor. Below, six nameplate fields to read: model and phase, power, volts and amps, suction, head and flow, port sizes. NAMEPLATE A suction (in) B delivery (out) Nova NH01 READ THESE SIX 1Model, phase, HzNH01 · 1 Ph · 50 Hz2Power0.5 HP · 0.37 kW3Volts and ampsV ____ A ____4Suction / priming____ m5Head and flow____ m · ____ L/min6Port sizes (A and B)____ mm / ____ mm
Nova does not publish the NH01's figures where we could find them, so they are not printed here. They are on the plate on the motor.
Is it for your house

Three answers, and only the first is this pump

Yes: the NH01

Ground floor or G+1, tank on the roof, water within about 5 m below the pump in May, one or two bathrooms. This is most houses on a shallow boring or sump in Muzaffarpur.

Go up: the NF01

G+2, a tank on a stand, three or more bathrooms, or a boring far from the house. See Nova NF01, 1 HP. It does not pull from much deeper; it pushes higher and fills faster.

Go down: a submersible

Water that stands deeper than about 7 m in May. No self-priming pump of any HP lifts that reliably. We can order a submersible; ask on WhatsApp for the time. Why.

Not sure how deep your water stands, or how high the tank is? The pump picker does the sum with your own numbers. A weak shower under a full tank is a different problem: pressure pump.

Read the nameplate

Six figures on the pump decide how it is fitted

We have not printed a head, flow or suction figure for the NH01.We looked for a maker's datasheet or product page for it on 13 Nov 2026 and found none. A number we have not seen would be a guess, so the figures come from the plate on the pump in front of you, and we read it with you at the counter. Send a photo of the plate on WhatsApp and we will check it against your house.
On the plateWhat it tells you, and what to do with it
1Model, phaseNH01, single phase, 50 Hz is the ordinary house supply. A plate that says 3 Ph is a different pump.
2Power0.5 HP is 0.37 kW. Check the box and the plate say the same.
3Volts and ampsAmps decide the wire. Up to 12 A: 2.5 sq mm copper and a 16 A C-curve MCB, on the pump's own line. Above 12 A, send us the plate. A wide volt range helps where the evening voltage drops (Crompton rates its home pumps 180–260 V).Wire for a motor pump · B or C curve · low voltage
4SuctionHow far below the pump it can pull. Compare it with the water level in May, not October. We plan on 7 m for a 0.5 HP whatever the plate says, with a short, straight suction pipe. If the plate or manual gives less than your pull, or your suction pipe is long, fit a foot valve (some makers prime without one only up to 3 m).How deep can a pump pull
5Head and flowHead is the total height the pump can lift, and the flow falls as the height rises. Your head is the pull, plus the push to the tank, plus 10% for the pipe. Keep it well below the maximum. The sum is in 0.5 HP or 1 HP.
6Port sizesThe two openings, A (suction) and B (delivery), decide your pipe and fittings. We keep 1 inch UPVC pipe; read the plate before you buy pipe. Pipe for a pump
Head range, 0.5 HP pumps of other makers
Head range of 0.5 HP pumps from other makersFour 0.5 HP self-priming pumps from other makers list a head range starting at 6 m and ending between 24 and 30 m. A shaded band marks 10 to 15 m, what a one-floor or G+1 house here needs. The Nova NH01 bar is dashed and empty: its figures are on the nameplate.our houses: 10–15 mDuke RG-506–24KSB Cute Plus6–27Usha MMB 25466–28Crompton Mini Master II6–30Nova NH01read the nameplate0102030m of total head
Total head in metres, as each maker's figure is listed on marketplace pages (sources below). The Nova bar is empty on purpose.
For scale

Other makers' 0.5 HP pumps work from 6 m to 24–30 m of head

Four 0.5 HP self-priming pumps from other makers list a head from 6 m up to 24 to 30 m. A one-floor or G+1 house here needs about 10 to 15 m by our sum, well inside that. Use this as the normal range for a 0.5 HP, not as the NH01's figures; its plate may differ.

The head range is where a pump works at all, not where it works well. Flow is least at the top: Crompton lists 2,600 to 600 litres an hour for its 0.5 HP Mini Master II across 6 to 30 m, a quarter of the flow at the far end. So a pump asked to lift near its maximum fills the tank slowly and runs hot. That is why a tall house goes to the 1 HP.

The NH01, fitted
Nova NH01 fittedThe pump stands at ground level beside the boring. A short straight suction pipe with a foot valve goes down to the water, which stands about 7 m below at most in May. From the pump the delivery pipe rises through a union and a ball valve to the tank on the roof. The pump has its own 16 amp C-curve MCB on 2.5 sq mm wire. foot valve pull: plan ≤ 7 m water level in May short andstraight NH01 union ball valve roof tank 16 A C own line,2.5 sq mm wire
Pump at ground level, as close to the water as you can get it. Every metre it sits above the water is pull.
What to buy with it

The pump, six small parts and a breaker

The pump alone does not make a working set. Suction pipe with a foot valve to the water, a union and a ball valve on the delivery side so the pump comes off for service without cutting pipe, Teflon tape on every thread of the suction side, and its own wire and MCB. The mistakes that follow when one is missed are on the size guide; a pump that runs but gives no water is nearly always an air leak on the suction side (

Prices are from our latest bill and change often. Please confirm today's rate on WhatsApp or call before buying.

pump not lifting water).

Foot valves, float switches, auto-starters and anything not on the list we can order for you; ask on WhatsApp for the time it takes.

Price, stock, warranty

What to expect when you buy it

Price

Ask rate per pump, set each day on the rate board, with GST on the bill. We do not quote from memory.

Stock

We sell the NH01 at Rewa Road and can order it for you; ask on WhatsApp for the time it takes. Genuine Nova, with a GST bill.

Warranty

The period is printed on the warranty card in the box; we read it with you. Keep the card and the GST bill together.

If it fails

A self-priming pump is simple enough for any local mistri to open. For a warranty claim, bring the pump with its card and bill to the store.

WhatsApp: Nova 0.5 HP price and stock
Questions people ask us

Short answers

What is the price of the Nova 0.5 HP pump in Muzaffarpur?

Our price for the day is on the rate board, with GST on the bill. We do not quote one from memory, because it changes with the day. Ask on WhatsApp with "Nova 0.5 HP – price & stock?" and we reply with today's figure.

Is a 0.5 HP pump enough for a two-floor house?

For a ground-plus-one house with the tank on the roof, water within about 5 m below the pump, and one or two bathrooms, yes. For G+2, three or more bathrooms or a long pipe run, take the 1 HP. The reasons and the sum are in 0.5 HP or 1 HP.

How deep can the NH01 pull water?

We plan on 7 m for a 0.5 HP, measured to the water in May, and keep the suction pipe short and straight. Beyond that you need a submersible; more HP does not help. See self-priming or submersible and how deep can a pump pull.

What are the NH01's suction, head and flow figures?

Nova does not publish them where we looked, so we will not print numbers we have not seen. They are on the nameplate on the motor. Send us a photo of the plate and we will check it against your house.

Which wire and MCB for it?

If the nameplate says up to 12 A, use 2.5 sq mm copper for phase, neutral and earth, with a 16 A C-curve MCB on the pump's own line. Above 12 A, send us the plate. More: wire for a motor pump and B or C curve.

Can I run it on an inverter?

A motor draws two to three times its running current for a moment when it starts, and that jolt is what trips small inverters. Check the size first: inverter size for your house.

The pump runs but no water comes. Why?

Most often air is getting in on the suction side: a loose joint, no Teflon on a thread, a worn foot valve, or the pump sitting too high above the water. See pump not lifting water.

Will it give strong pressure in the shower?

No. A pump that fills the roof tank does not add pressure under a full tank. A weak shower needs a booster on that bathroom's line: pressure pump for home.

Read next

Sashikesh Kumar
Diploma in Electrical, Tashya Ventures

Looks after wiring, MCBs, fans, inverters and pumps at our Reva Road store, Muzaffarpur. The comparison figures here are other makers' own, from the pages listed below, checked on 13 Nov 2026. Nova's figures are not published where we looked, so this page sends you to the nameplate. The wire and MCB rule, and the 7 m pull we plan on, are our working rules and are labelled so.

Where the numbers come from

  1. Nova NH01: no maker datasheet or product page found in web searches on 13 Nov 2026. Model and 0.5 HP single phase are from our own purchase bill. Every other Nova figure is left for the nameplate.
  2. Crompton MINI MASTER II, Moglix listing: 0.5 HP, 0.37 kW, head 6–30 m, 600–2600 L/h, 25 mm ports.
  3. Duke RG-50, Moglix listing: head 6–24 m, primes to 3 m without a foot valve.
  4. KSB Cute Plus, Shakedeal listing: head 6–27 m. Usha MMB 2546, Shakedeal listing: head 6–28 m.
  5. Crompton, 0.5 HP water pumps: 180–260 V rating, suction up to 7.0 m.
  6. Wire and MCB rule: V-Guard Classo+ table (2.5 sq mm in a wall pipe carries 18 A, so a 16 A MCB); earth the same size as phase (IS 732). 1 HP = 746 W is the standard figure.
  7. Houses need 10–15 m of head, and the 7 m pull: our working figures from the size guide, which gives its own sources. Marketplace listings can be wrong; check the plate.

Send us your house and your boring

Floors, bathrooms, how deep the water stands in May. We will tell you 0.5 HP or 1 HP, what goes with it, and today's price, on WhatsApp.

TASHYABUILDING SOLUTIONS · MUZAFFARPUR
WhatsApp 90310 74624tashyaventures.com